Last additions - User galleries |
191 viewsJan 11, 2017
|
|
196 viewsDec 06, 2016
|
|
348 viewsNov 21, 2016
|
|
374 viewsJul 28, 2016
|
|
378 viewsJul 11, 2016
|
|
347 viewsJul 11, 2016
|
|
Step 09: tacho circuit and motor unit352 viewsonce you removed the five screws you can remove the unit for the conversionJun 22, 2016
|
|
Step 12: resistor R2 (15k Ohm) partialy desoldered331 viewsresistor R2 (15k Ohm) partialy desolderedJun 22, 2016
|
|
Step 11: solder points of resistor R2 (15k Ohm)332 viewsdesolder resistor R2, locking pliers are one way to pull the resistor leg loose once the solder point is softenedJun 22, 2016
|
|
Step 08: screws (5) holding the circuit and motor in place325 viewsunscrew these 5 screws to remove the circuit and motor (the two items are fixed together and come off as one)Jun 22, 2016
|
|
Step 10: resistor R2 (15k Ohm)337 viewsthis is the resistor R2 (15k Ohm) that needs to be replaced with a 10.2k Ohm unitJun 22, 2016
|
|
Step 07: circuit and motor revealed322 viewsonce you removed the two fascia panels and light distribution thinggies, the circuit board and motor are revealed - this is what we have to remove in the next step.Jun 22, 2016
|
|
Step 04: fascia screws (4)328 viewsremove the 4 screws holding the two fascia panels in placeJun 22, 2016
|
|
Step 03: tacho and speedo needle323 viewsremove the 2 needles, a thin fork makes it easier (just put something between the fork and fascia to prevent scratches)Jun 22, 2016
|
|
Step 06: light distributors315 viewsremove the two light distributors, they are not screwed in anymore just held in position with two locating pegsJun 22, 2016
|
|
489 files on 33 page(s) |
|
|
|
|
|
|
|
|
28 | |
|
|
|
|