 Last additions - User galleries |
Step 07: circuit and motor revealed322 viewsonce you removed the two fascia panels and light distribution thinggies, the circuit board and motor are revealed - this is what we have to remove in the next step.Jun 22, 2016
|
|
Step 04: fascia screws (4)328 viewsremove the 4 screws holding the two fascia panels in placeJun 22, 2016
|
|
Step 03: tacho and speedo needle323 viewsremove the 2 needles, a thin fork makes it easier (just put something between the fork and fascia to prevent scratches)Jun 22, 2016
|
|
Step 06: light distributors315 viewsremove the two light distributors, they are not screwed in anymore just held in position with two locating pegsJun 22, 2016
|
|
Step 05: fascia panels315 viewsremove the two fascia panelsJun 22, 2016
|
|
Step 01: retaining tabs top (3)298 viewspush down on the 3 retaining tabs on the top (best start on the side) to loosen the transparent coverJun 22, 2016
|
|
Step 02: retaining tabs bottom (3)296 viewspush down on the 3 retaining tabs on the bottom (best start on the side) to remove the transparent coverJun 22, 2016
|
|
Conversion test successful328 views10.44kOhm instead of 15kOhmJun 21, 2016
|
|
AE86 custom 10krpm fascia with ECON/PWR light option300 viewsCustom 10krpm fascia with ECON/PWR light option for OEM cluster.Jun 09, 2016
|
|
Water/Oil cutout dimensions305 viewsWidth 79.7mm; Height 15.7mmJun 09, 2016
|
|
183 viewsJun 01, 2016
|
|
199 viewsMar 31, 2016
|
|
rpm simulation on OEM cluster260 viewsFeb 17, 2016
|
|
10krpm custom fascia in motion273 viewsFeb 14, 2016
|
|
201 viewsFeb 11, 2016
|
|
| 493 files on 33 page(s) |
 |
|
|
|
|
|
|
|
|
29 | |
|
|
|
